The State of Consumer 3D Printing

Categories

There were several new 3D printers introduced at the Consumer Electronics Show a couple weeks ago. The Replicator, from Makerbot, is probably the most impressive from a price/performance perspective: a large print area, two extruders, and fully assembled for under $2,000. Unfortunately, from everything I've seen, the software is pretty much the same as Makerbot has always used, and that's a significant weakness. I want to just print and not have to fiddle with the settings to get good results. Better software and less fussing is why I chose the Up even though it is more expensive.

Another new model, the Cubify, is aimed squarely at the consumer market with a $1,300 entry point and an aggressively friendly look. They take the inkjet printer approach by sellng the printer cheaply but using a proprietary cartridge design to force you to buy the consumables at outrageous prices. It's hard to tell exactly how much Cubify's plastic costs, but my back-of-the-envelope calculation is that it's between $0.10 and $0.20 per gram--which would make it as much as five times the price of the same stuff from a third party.

Despite these new products I'm skeptical that 3D printing is really ready for the mass consumer market. I (and many other hobbyists) really enjoy designing and printing stuff, and I'm willing to devote a lot of time to tweaking my models, seeing what works, and accepting a fair amount of failure along the way. Not every model will print well, and there's a certain amount of art and experimentation which goes into designing a model which gives good results. An ordinary consumer isn't going to expect that.

There are also safety issues. Not loss-of-life-and-limb safety, but lots of opportunities for minor cuts and burns. Parts of the printer get hot enough to burn, and cutting support material off a model entails all the normal hazards of working with sharp knives. I speak from experience, since I was careless when trimming the support raft off one of my models a couple weeks ago. The knife slipped, and I needed seven stitches in my finger. I am now much more careful, but these kinds of injuries will be common until multi-headed printers and dissolving support become the norm.

I still think there's a good chance that someday 3D printing will be a mainstream household technology. Just not today. For all the breathless press coverage over the past few weeks, this is not yet ready for the average Joe and Jane.